Issue(s):
- During homing, getting alarms like "Homing Fail. Could not find limit switch"
- During homing, machine is moving away from where the sensors are mounted
Resolution:
- Make sure your machine is jogging in the expected direction.
If not, go to Config, select Motors in the sidebar, then under Step direction invert use the toggles to reverse the directions for each axis affected. Press Apply Settings and turn OFF and ON your controller. - Try homing again.
- If it is still going in the wrong direction, go to Config, select Homing/Limits in the sidebar, then under Homing direction invert, use the toggles to reverse the direction of homing, so that the machine will head TOWARDS the sensors. Once you make the changes, press Apply Settings then turn OFF/ON your controller.
This is the default Homing direction invert setting for the AltMill: